Sullair WSPC - System Compatibility; Installing the WSPC User Interface Software

WSPC USER INTERFACE Part 1: User Level
4
Features of the WSPC User Interface software include:
• Two-way communication channel between the user and the compressor
controller.
• A comprehensive view of the compressor controller’s operation at the WSPC
interface.
• Adjustment of all modifiable parameters of the compressor controller.
• Ability to control the compressor remotely.
• Access to data relating to all compressors connected as a sequence system.
• Password protection capabilities to limit access to data and controls.
• A data log feature which compiles operational, service, and error data of the
compressor or compressor system.
1.2 SYSTEM COMPATIBILITY
Before beginning the installation process, your computer should meet the
following minimum requirements.
• PC–compatible computer (Pentium® IV based, 1.0 Ghz processor
recommended)
• Windows 2000 or Windows XP operating systems. Windows 2000 may
require special processing software to properly operate the WSPC software.
• CD ROM drive
• 125 Mb of available hard disk space
• 256 Mb of available RAM memory
• Color monitor
• RS232 communications capability
1.3 INSTALLING THE WSPC USER INTERFACE SOFTWARE
Follow the instructions accompanying the WSPC Installation package. The
actual installation media may be CD, internet, network, memory sick, or other
means, and the procedure will be specific to that media. This installation will
create a folder on your disk drive, and install the necessary files into that folder.
Make a note of this location, as it may be necessary for future updates. The
default location for all saved files will also be in that folder, but you may browse
to save into any other location in your PC as desired. By default, the folder will
be “WSPC, and will be located in a “Sullair” folder: “..\Sullair\WSPC”