Part 1: User Level WSPC USER INTERFACE
51
Figure 5.5 Main Motor VFD Status box
5.8 ADJUSTMENTS TAB
As discussed earlier in this manual, the adjustment tab allows the user to modify
certain control parameters of the compressor operation. In addition to the
general control parameters previously described, two VSD adjustments become
available when the WSPC is connected to a VSD compressor. These VSD
control parameters are setpoint pressure and cost per kilowatt-hour. See Figure
5.6.
To view the VSD control parameters, click the Adjustments tab to present the
Adjustments display. The additional VSD parameters are located in the left
column of the display.
The VSD control parameters are defined as follows (ref. Figure 5.6):
To Next Page
Loading...