Sullair WSPC - Wspc Display Descriptions; Compressor Status Bar; Status Bar Components

Part 1: User Level WSPC USER INTERFACE
15
SECTION 3 WSPC DISPLAY DESCRIPTIONS
3.1 COMPRESSOR STATUS BAR
Located on the left edge of the WSPC User Interface program window, the
Compressor Status Bar displays information related to the compressor current
operation. See Figure 3.1. The information appearing in the Status Bar is
machine generated, view only data.
Figure 3.1 Default Screen: Compressor Data Display
Above the Status Bar is a button that allows the user to connect or disconnect
communication between the WSPC and the WS Controller. Clicking the
“Connect” button will alternately connect and disconnect communication between
the software and the controller.
An additional button (labeled Unload) may appear in the Status Bar when the
WSPC interface is configured to control the compressor operation remotely.
Refer to Sequencing and Protocol Manual for an explanation of this feature.
3.1.1 Status Bar Components
Listed below is the information that is displayed in the fields of the Compressor
Status Bar.
Compressor Operating Mode – The Operating Mode is the manner in which the
machine operation is being controlled. There are five Operating Modes:
AUTOMATIC, MANUAL, OFF, FAULT, and UI COMM.
Operating State – The state of the compressor operation in response to the
current mode and current conditions. The operating state essentially describes
what the machine is currently doing.
Status Bar
Compressor
Operating Mode
Operating State
Compressor T1
Temperature
Sump Pressure
Compresso
r
Line Pressure
Controlle
r
Control
Voltage