WSPC USER INTERFACE Part 2: Administrator Level
64
6.5 ADMINISTRATOR ADJUSTMENTS (ADMIN) DISPLAY
The Administrator Adjustments (Admin) display tab is available only when an
administrator level profile is active. This display allows the administrator to edit
the ID’s of specific controller inputs and to make zero calibration adjustments of
measured values between the compressor system and the controller. The Admin
user can view the current assignments of the controller input registers and make
adjustments as necessary. See Figure 6.10. The inputs shown in the figure are
for reference and vary based on specific machine configurations.
Changes can only be made at the Admin display while the compressor is
stopped. When the compressor is running, the fields of the Admin display are
inactive. Changes made at the Admin display will be applied to the WS
Controller within a few seconds after entry.
Figure 6.10 Administrator Adjustment Display
Described below are parameters that can be edited by the Administrator at the
“Admin” display. The units and language appearing in the “Administrator
Adjustment” display correspond to the settings applied when the Administrator
profile was created.
To Next Page
Loading...