Sullair WSPC - Service Reminders

WSPC USER INTERFACE Part 1: User Level
24
High Air Filter dP – Air filter pressure differential is high indicating that the air
filter unit needs to be checked or changed.
High Temperature 1, 2, or 3 – Compressor Temperature at the specified temp
probe location is approaching the set high limit.
Low Temperature 1, 2, or 3 – Compressor Temperature at the specified temp
probe location is approaching the set low limit.
Power Interruption – An interruption in power to the compressor has occurred.
Sequence Comm Error – Communication problem exists between the
compressor controllers set up for sequential operation.
User Warning – A user furnished switch has been activated.
Low Computer Battery – Indicates that the controller internal battery is low and
needs to be replaced.
Dryer Warning – Indicates that the compressor system dryer needs to be
serviced.
Refer to the WS Controller Instruction Manual for additional instructions on
actions to be taken when warning conditions exists.
3.5.2 Service Reminders
Service Reminders may inform the user that a particular component of the
compressor is recommended for servicing. An Administrator may set service
intervals and reset the service reminders. The following service reminders can
appear under the “Recommended Service” heading:
Oil (Fluid) Filter Change – The compressor fluid filter life interval has expired.
Change the fluid filter within the time frame noted in the machine operation
specifications.
Separator Change – The compressor fluid separator life interval has expired.
Change the separator within the time frame noted in the machine operation
specifications.
Air Filter Change – The compressor air filter life interval has expired. Change
the air filter within the time frame noted in the machine operation specifications.
Oil (Fluid) Analysis – Fluid analysis interval has expired. Schedule the
compressor fluid analysis per machine operation specifications.
Oil (Fluid) Change – The compressor fluid life interval has expired. Change the
compressor fluid within the time frame noted in the machine operation
specifications.
Other Maintenance – Other periodic maintenance should be performed as
scheduled per machine operation specifications.
The “Interval” fields show the recommended hours remaining until the next
servicing is due for the above listed items. A zero value indicates the reminder is
disabled.