Sullair WSPC - Compressor Data Display (Default Screen); Compressor Run Data

WSPC USER INTERFACE Part 1: User Level
16
Compressor Temperature 1 – The internal temperature of the compressor.
Sump Pressure – The compressor sump pressure.
Line Pressure – The discharge pressure of the compressor.
Control Volts – The actual voltage of the compressor control supply.
Additional data may be displayed in the Compressor Status Bar depending on
user access level and machine configuration.
3.2 COMPRESSOR DATA DISPLAY (DEFAULT SCREEN)
The “Compressor Data” display is the window that appears when the WSPC
Interface is initialized. See Figure 3.2. If the Compressor Data display is not
showing on the monitor, access the display by clicking on the “Compressor Data”
tab. At this display the user can monitor compressor operating information.
Figure 3.2 Compressor Data Display
3.2.1 Compressor Run Data
The information presented at the Compressor Data display is described below.
Machine hours – Total number of hours the controller has been monitoring
compressor operation.
Compressor enabled hours – Total number of hours the compressor has been
enabled to run.
Motor running hours – Total number of hours the compressor motor has been
running.
Machine
Operation
Data