WSPC USER INTERFACE Part 1: User Level
26
Figure 3.11 Sequence System Display
Status – displays the operating state of each compressor in the sequence. The
sequence state describes the operational role a machine is performing as a part
of the sequence. The various states that may appear in the “Sequence status”
column are:
Starting – Indicates the compressor is starting up.
Full Load – Indicates the compressor is fully loaded.
Trim – Indicates the compressor is operating as the trim machine in the
sequence.
Loaded – Indicates the compressor is running loaded.
Unloaded – Indicates the compressor is running unloaded.
Manual Stop – Indicates the compressor is stopped by the operator.
Remote Disable – Indicates the compressor is removed from sequencing
remotely.
Remote Stop – Indicates the compressor has been stopped remotely.
E-Stop – Indicates a compressor fault.
To Next Page
Loading...