WSPC USER INTERFACE Part 1: User Level
42
Figure 4.4 Edit Profile Window
6. In the “Notes” field, enter a brief note relating to the compressor system.
7. In the “Language” field, click on the drop down arrow and select the desired
language for the WSPC software.
8. Select the desired “Units of Measure.” These settings determine the units of
measure to be displayed by the WSPC software. Units selected here will not
affect units displayed on the WS Controller user interface.
a. At the “Pressure” field, click on the drop-down arrow and select the
pressure unit as PSI, Bar, or Kpa.
b. At the “Temperature” field, click on the drop-down arrow and select the
temperature unit as Deg F or Deg C.
c. At the "Flow" field, click on the drop-down arrow and select the air flow
unit as ACFM, M
3
/hr, M
3
/min, L/min, L/sec.
d. At the "Power" field, click on the drop-down arrow and select the power
unit as KW or HP.
e. At the "Volume" field, click on the drop-down arrow and select the volume
unit as KCF, Feet3, Gallons (US), Liters, M3, and KM3.
9. Select the desired “Communication Port” settings. These settings control
communication between the WS Controller and the WSPC software.
a. At the “Modbus Address” field, click the up/down arrows to increment to
the required modbus communication ID. The default modbus value is set
To Next Page
Loading...