Part 2: Administrator Level WSPC USER INTERFACE
59
2. Click the down arrows for the machine model for which the controller is to
be commissioned. See Figure 6.3.
Figure 6.3 Commission Select
3. After the Model has been chosen, select the attributes that apply to the
specific machine being commissioned. Only those options that have
multiple choices may be selected.
a. Click “Hp” to select the horsepower of the compressor motor.
b. Click “Hz” to select the compressor motor frequency.
c. Click “Pressure” to select the compressor pressure rating.
d. Click “Cooling” to select the compressor cooling method.
e. Click “Motor” to select the compressor motor phase type.
f. Click “Volts” to select the compressor operating voltage.
g. Click “Dryer” to select the compressor dryer type.
4. When all appropriate attributes have been selected, click “OK”. The
program will present a “Continue to Commission” option box. See Figure
6.4.
Figure 6.4 Commissioning Confirmation
NOTE
Use care to select the proper machine model. All machine attributes must
match the model selected during commissioning to ensure proper and safe
operation.
To Next Page
Loading...