SUMMACUT D520 - General Information; Introduction and Cutter Models

General Information 1-1
SECTION 1
GENERAL INFORMATION
1.1. INTRODUCTION
The SummaCut range of cutters has been designed to produce computer-
generated graphic designs on cut sheet or roll vinyl media. By replacing the
knife with a fibre tip pen, the cutter can also be used to produce inexpensive
previews of new graphic designs on paper.
This manual covers the following SummaCut Series cutter models:
• The SummaCut D520, which can handle media widths from 70 mm up to
675 mm (2.7” to 26.6”)
• The SummaCut D620, which can handle media widths from 70 mm up to
775 mm (2.7” to 30.5”)
• The SummaCut D760, which can handle media widths from 70 mm up to
915 mm (2.7” to 36”)
• The SummaCut D1020, which can handle media widths from 120 mm up to
1175 mm (4.7” to 46.3”)
• The SummaCut D1220, which can handle media widths from 120 mm up to
1375 mm (4.7” to 54.1”)
The term ‘ summaCut Series Cutters’ is used when information is provided which
is common to all members of this series. The specific model terms D520, D620,
D760, D1020 and D1220 are used when information pertains only to that
particular model.
1.1.1. PRODUCT FEATURES
The following are the main features of the SummaCut Series cutters.
• Easy to use computer control via software utility.
• Variable media widths.