SUMMACUT D520 - Knife, Pen and Pouncing Tool; Summacut Series Media Specifications (Continued); Summacut Series Knives, Pens and Pouncing Tools

SummaCut Series Cutters User’ s Manual
General Information 1-5
D520 D620 D760 D1020 D1220
Front margin
18 0.7 18 0.7 18 0.7 18 0.7 18 0.7
Rear margin Sensor on
42 1.7 42 1.7 42 1.7 42 1.7 42 1.7
Sensor off
25 1 25 1 25 1 25 1 25 1
* Media lengths greater than 4 m (13 feet) can be handled, but compliance with
specifications is not guaranteed (will be dependent on media type, media size and other
parameters not mentioned here). With the optional media support system, the tracking
performance is 8 m / 26 feet.
** For positioning of the pinch rollers (see section 1.8.)
TABLE 1-2 :
SUMMACUT SERIES MEDIA SPECIFICATIONS (CONTINUED)
Vinyl Types
A wide range of vinyl types has been evaluated and tested on the SummaCut
Series cutters. When using duly certified media, operation in accordance with
the functional specifications of the model is warranted. Other media should be
certified by Summa before use to ensure performance in compliance with
specifications.
For a full list of all duly certified media suitable for friction drive operation, see
Appendix A.
Plotting Paper
Bond paper (120 g/m² recommended)
1.2.3.KNIFE, PEN AND POUNCING TOOL
The SummaCut cutters are supplied with two standard knife blades (for vinyl
media) and a black fibre tip pen.
Knife
Medium Quantity
Standard knife standard, reflective
& fluorescent vinyl
types
2 off
Knife for masking stencil masking stencil &
thick material
optional
Pen
Colour Quantity
Fibre tip pen black 1 off
Pouncing tool
Paper Optional
TABLE 1-3:
SUMMACUT SERIES KNIVES, PENS AND POUNCING TOOLS