SummaCut Series Cutters User’ s Manual
Operation 2-9
2.2.14. RTS/DTR
The RTS/DTR submenu controls the Request To Send (RTS) and Data Terminal
Ready (DTR) signals of the cutter’ s RS-232-C serial communications interface
for hardware handshaking.
The RTS/DTR default value is TOGGLE.
RTS/DTR can be set to TOGGLE (hardware handshaking) or HIGH (software
handshaking).
2.2.15. HP-GL ORIGIN
The HP-GL ORIGIN parameter will only be displayed if the PLOT LANGUAGE is
set to HP-GL. (See Paragraph 2.2.9.) The HP-GL ORIGIN submenu is used to set
the origin in the centre (see HP-GL 758x) or in the bottom-right corner (see HP-
GL 7475) of the media loaded.
The HP-GL ORIGIN option can be set to RIGHT_FRONT or CENTER.
If the cut is found to be incomplete, and is wholly located in the upper left
corner of the media, then modify the HP-GL ORIGIN setting to RIGHT FRONT. If
the cut is found to be incomplete, and is wholly located in the lower right
corner of the media, then change the HP-GL ORIGIN setting to CENTER.
2.2.16. MEDIA SENSOR
The MEDIA SENSOR parameter is used to activate or deactivate the media
sensors.
The sensors detect whether media is loaded, or detect the end of media. The
sensors prevent damage to the cutting strip and knife tip.
2.2.17. AUTOLOAD
The AUTOLOAD option enables the user to the change the vinyl unroll
proceedings. When AUTOLOAD is ON , the cutter will automatically unroll the
vinyl when needed. When the AUTOLOAD option is OFF, the operator himself
should unroll enough media before starting to cut.
The default setting is ON. The best results and performance are guaranteed
when using this setting.
To Next Page
Loading...