SUMMACUT D520 User Manual

*

SUMMACUT D520 Specifications

General

Cutting Force	0-400 grams
Contour Cutting	Yes
Voltage	100-240 VAC
Frequency	50-60 Hz
Maximum Cutting Thickness	0.25 mm (10 mils)

Summary

Important Information and Notices

Pre-operation Important Information

Key details before starting, including warranty registration.

General Information

Introduction and Cutter Models

Detailed Specifications

Technical specs for cutter, media, interface, performance, and environment.

Setup and Installation Procedures

Guide to powering up, grounding, and installing tools.

Media Loading and Handling

Operation and Cutter Control

Control Panel Functions and Indicators

Summa Cutter Control Software Settings

Guide to configuring cutter parameters via the software.

Interface and Communication Setup

Maintenance and Cleaning

Cleaning Drive System and Sensors

Operating Voltage Conversion

Steps for changing the cutter's operating voltage and fuse settings.

Interface and Connectivity

System Setup for Communication

Contour Cutting Procedures

Contour Cutting Overview and Preparation

Design Creation and Cross-Mark Placement

Printing and Cutter Setup for Contour Cutting

Executing Contour Cuts

Registering cross-marks and performing the actual contour cutting.