SUMMACUT D520 - Default Chapter; Table of Contents

To Next Page

To Previous Page

User’s Manual SummaCut Series Cutters

Table of Contents TOC-i

TABLE OF CONTENTS .................................................................................. Page

1. GENERAL INFORMATION

1.1. Introduction...................................................................................................1-1

1.1.1. Product features...........................................................................................1-1

1.1.2. SummaCut Series User Manual ...................................................................1-3

1.2. Specifications................................................................................................1-4

1.2.1. Cutter.............................................................................................................1-4

1.2.2. Media ............................................................................................................1-4

1.2.3. Knife, pen and pouncing tool .....................................................................1-5

1.2.4. Interface........................................................................................................1-6

1.2.5. Firmware........................................................................................................1-6

1.2.6. Performance.................................................................................................1-7

1.2.7. Certifications .................................................................................................1-7

1.2.8. Environmental...............................................................................................1-7

1.2.9. Electrical .......................................................................................................1-8

1.3. Cutter accessories and consumables ........................................................1-9

1.4. Rear panel components ............................................................................1-10

1.5. Front panel controls....................................................................................1-11

1.6. Powering up the cutter...............................................................................1-13

1.6.1. Grounding...................................................................................................1-13

1.6.2. Power-up procedure .................................................................................1-14

1.7. Installation of a knife, pen or pouncing tool ............................................1-15

1.7.1. Knife installation..........................................................................................1-15

1.7.2. Pen installation............................................................................................1-18

1.7.3. Installation of a pouncing tool ..................................................................1-19

1.8. Loading media...........................................................................................1-20

1.8.1 Positioning the pinch rollers .......................................................................1-20

1.8.2. Feeding and positioning media................................................................1-21