SUMMACUT D520 - Summacut Series User Manual

SummaCut Series Cutters User’ s Manual
General Information 1-2
• Interchangeable pen for producing preview plots of sign designs on paper.
• Interchangeable pouncing tool.
• Adjustable knife pressure and offset settings controlled by microprocessor.
• Communication with host computer via standard serial RS-232-C
interface.
• 6-key control panel with LED indicators.
• Metric or English units.
• Menu mode for selection of the cutter’ s power-up operating configuration,
controlled by microprocessor.
• Wide variety of axial cutting speeds (in metric or English units).
• Up to four separate user configurations stored in the non-volatile memory.
• Automatic media pull from roll.
• Automatic media sensing.
• User changeable origin to any location.
• Concatenation and curve smoothing to obtain better cut quality.
• Manual knife for cutting off the finished sign.
• Knife depth and offset test.
• Overcut for easy weeding.
• Optional media support system to guarantee tracking of longer signs
(Standard for D1020 and D1220).
• User-selectable DM/PL
TM
, HP-GL
TM
and HP-GL/2
TM
software protocols.
• Optional stand (Standard for D1020 and D1220).
• Multiple recut feature