SUMMACUT D520 - Installation of a Pouncing Tool

SummaCut Series Cutters User’ s Manual
General Information 1-19
• All the cutter’ s parameters will now be displayed. Scroll to the ‘Tool’
parameter and select ‘PEN’.
• Click on the ‘OK’ button to go back to the main window.
• Analogous to 1.7.1., point 6, the pen pressure can be changed.
1.7.3.INSTALLATION OF A POUNCING TOOL
The SummaCut cutters can also be operated with a pouncing tool. After
replacing the knife with a pouncing tool, the cutter can be used as a pouncer.
è To install the pen, proceed as follows:
• Load a piece of media in the cutter (See 1.8.). Make sure that none of
the two lower LED’ s are on. If one LED is on, press on the respective
button to turn it off.
• Start up the Summa Cutter Control on your host PC. Press the ‘Menu’
button on the main screen. (For more information about setting up
the port parameters, read the help instructions included in the
program. )
• All the cutter’ s parameters will now be displayed. Scroll to the ‘Tool’
parameter and select ‘PEN’.
• Click on the ‘OK’ button to go back to the main window.
• Analogous to 1.7.1., point 6, the pouncing pressure can be changed.