SummaCut Series Cutters User’ s Manual
Operation 2-6
The default knife offset value is .45 mm.
The value can be set between 0 and 1 mm.
Make sure that the selected knife offset value matches that of the knife. Some
fine tuning may be necessary because of the mechanical tolerances on the
knife. To verify the knife offset, a test can be cut by clicking on the ‘Cut test
pattern’ button.
If the offset value is set too low, the rectangles will not close.
When the offset value is set too high, the rectangles will be distorted.
The offset test is illustrated below.
2.2.4. POUNCING GAP
The pouncing gap submenu is used to set or modify the distance between the
pounced wholes. This routine applies to the pouncer only.
The default pouncing gap value is 0 mm.
The value can be set between o and 50 mm.
On the LCD, the active pouncing gap value is marked with an *.
2.2.5. VELOCITY
The VELOCITY is used to set or modify the velocity of the tool.
The default velocity is 500 mm/s (20 ips).
The velocity can be set between 50 mm/s (2 ips) and 600 mm/s (24 ips).
2.2.6. OVERCUT
The OVERCUT parameter enables you to generate an overcut in order to
facilitate weeding of the cut.
The default overcut is set to 1.
The overcut setting can be disabled (=0) or set to any value between 0(=off)
and 10. One unit is about 0.1 mm or 0.004 ".
2.2.7. CONCATENATION
The CONCATENATION feature increases the speed and quality with which cut
data having a very high resolution is cut. However, when changing over to
normal characters again, deactivate concatenation by setting this parameter
to 0.
To Next Page
Loading...