SummaCut Series Cutters User’ s Manual
General Information 1-14
For information about the conversion of the cutter’ s operating voltage and the
exact fuse ratings, see Section 3.2.
MAKE SURE THIS
IS CONNECTED TO A
MAKE SURE THIS IS
CONNECTED TO A
THREE-PIN
PLUG
EUROPE:
USA
OUTLET
:
THREE-PIN
KNOWN EARTH
KNOWN EARTH
FIGURE 1-3:
GROUND CONNECTION
!
IMPORTANT OPERATIONAL TIP
This cutter must only be used with a power outlet that is properly
grounded to ground. Use of an ungrounded outlet exposes the
operator to risk of electric shock and will also lead to malfunctioning
of the cutter.
1.6.2.POWER-UP PROCEDURE
è To power up the cutter, proceed as follows:
1. Make sure the cutter is placed on a flat, level and sturdy surface.
2. Plug one end of the AC power cord into the AC power cord receptacle
on the cutter’ s rear panel.
3. Plug the other end of the AC power cord into the wall socket.
4. Press the "I" side of the ON/OFF rocker switch on the left side plate to
switch the cutter ON.
5. The Power LED will flash up, and if media is loaded, the standard loading
procedure will take place.
To Next Page
Loading...