SUMMACUT D520 - Contour Cutting Procedures; Contour Cutting Overview and Preparation

Contour Cutting 5-1
5 Contour cutting on the SummaCut Series
5.1. INTRODUCTION
The SummaCut Series cutters have accurate alignment methods to
guarantee precise contour cutting.
Depending on the selected alignment method, the cutters can
counterbalance the following irregularities:
1. ROTATED DESIGN : If the printed design is not loaded straight into the unit,
the contour can be rotated equally to fit the printed graphic.
2. SKEWED DESIGN : If the X and Y axes of the printed design are not
perpendicular, the contour can be skewed to fit the printed design.
3. INCORRECTLY SCALED DESIGN : If the print size is different from the original
design in your software due to media expansion or shrinkage, or due to
printing inaccuracies, the contour can be scaled to fit the printed graphic.