SummaCut Series Cutters User’ s Manual
General Information 1-12
6. Sensors. - The sensors detect the presence of a media to avoid any
damage to the cutting strip. Upon powering up the machine, they cause
the media to move all the way to the front edge of the platen.
7. Pinch rollers.- The pinch rollers hold the media clamped between the
rubber rollers and the media drive sleeves.
8. Cutting strip.- Soft strip to avoid any damage to the knife tip when no
media has been loaded. Since cutting is done on the cutting strip, it is
essential that the cutting strip remains intact.
9. Roll feed. - This shaft can be removed from the cutter and inserted into a
media roll.
10. Manual cutting knife border: - This border can be helpful when cutting off
the sheet with the slitter knife.
To Next Page
Loading...