SUMMACUT D520 - Page 8

User’s Manual SummaCut Series Cutters
Table of Contents TOC-iii
3. MAINTENANCE AND CLEANING
3.1. Maintenance ................................................................................................3-1
3.1.1 Cleaning the drive system...........................................................................3-1
3.1.2 Cleaning the sensors....................................................................................3-2
3.2. Operating voltage conversion ....................................................................3-3
4. INTERFACE
4.1. Introduction...................................................................................................4-1
4.2. Interface notes..............................................................................................4-1
4.2.1 System setup.................................................................................................4-1
4.2.1.1 MS-DOS or PC-DOS operating system ........................................................4-1
4.2.1.2 Windows 3.xx.................................................................................................4.2
4.2.1.3 Windows 95 ...................................................................................................4.2
4.2.2 Serial interface connector on cutter ..........................................................4-3
4.3. Available serial signals ................................................................................4-3
5. CONTOUR CUTTING
5.1. Introduction......................................................................................................1
5.2. General ............................................................................................................5
5.3. Creating the design.........................................................................................5
5.4. Placing the Cross-marks .................................................................................6
5.5. Print the design ................................................................................................7
5.6. Loading the cutter and setting the parameters ............................................8
5.7. Registrating the cross-marks ..........................................................................9
5.8. Cutting the contour .......................................................................................10