104
Copy and Paste
The above is functions familiar to users. They are supported for graphic program
or most programs related to Word. This program also provides users with how to
easily use the functions.
① There are configuration data and sewing data in
the edit range as shown in the figure. Select the
circle configuration data.
② Select “Copy”on the Standard tool bar, or click
both “Crtl”and “C”to copy the circle configura-
tion data. After copy, the selected configuration
data has the dotted surrounding.
③ Move Mouse Point and click the mouse’s left
button at the proper position for a user to set up
where to paste. The small circle is displayed
based on the selected position.
④ Select “Paste”on the Standard tool bar, or click
both “Crtl”and “V”to paste the circle configur-
ation data. You can find that the selected conf-
iguration data has been pasted as shown in the
figure.
⑤ The following figures show that pastes the sew-
ing data created by the Point stitch.
The paste procedures are equal to those of the
above circle configuration data.
■■
Copy, Paste
To Next Page
Loading...
