153
To execute the SSPWriter Program
“Programming Module not found
Please check connection of power Adapter”
If the program is not execute in spite of selecting ROM Data I/O to execute
ROM function; SSPWriter program, execute it in the Start menu or execute
“SSPWriter.exe”to the installed folder. (Note: If ROM DATA I/O is executed
after execution of SSP-WE/0.9x registered in the Start menu, the above
problem occurs. This is not a problem of the program. If you execute ROM
by executing SSP-WE/0.9x in the installed folder, the SSPWriter is normally
executed.)
If SSP-Writer1 is connected with interface cable and Power Adapter, the SSPWriter
program can be immediately executed in the program.
Select ROM Data I/O in the program menu to display ROM item. Select this item to
execute the SSPWriter program. Upon selection, the following figure is displayed.
If the following error message is displayed upon execution of program in spite
that SSP-Writer1 is normally connected, execute it again after termination of
program, then the message is not displayed.
Let introduce the process to actually record “*.bin”files in the ROM through the
SSPWriter.
① If the SSPWriter program is executed, first of all
make Device Setting suitable for ROM Type.
SSP-Writer1 is set up to conforming to 27C256
ROM upon delivery. The Information Dialog
shows that Device Type is set up 27C256.
However, if you set up the device toc 27C512 in
the SSPWriter program, adjust it as follows:
To Next Page
Loading...
