139
① Connect serial transmission cable between the computer and the operation
box of the pattern.
Port and communication speed setting
② Click “Serial communication setting”under
menu.
③ After selection, “Serial communication dialog”
box will appear.
The following procedures explain design transmission process step by step.
Port Setting: The setting is equivalent to the bartack.
As shown in the serial port setting dialog below, change the value of the baud rate
only. The initial screen is set up to meet the 2070P speed, so select 115200 for
baud rate of the relevant port and press OK to exit. The serial port setting dialog
will disappear, and only the serial communication dialog will remain. Press “Port
setting”once again to select baud rate of the serial port setting dialog. Select
115200 and click OK to exit. Be sure to double-set baud rate.
To Next Page
Loading...
