39
Creating Configuration and Sewing Data
You can input each type using functional buttons in the sub-tool bar.
The phasic creation process of configuration and sewing data is shown
in the followings:
1. To input with the mouse
① Use the mouse’s left button to input any functional button you
want. The selected button becomes concaved
② Put the mouse button on any sewing range. Mouse cursor
displays in cross-shape .
③ Upon clicking the mouse’s left button at any input place, data
is inputted.
④ The configuration data of Spline is currently selected.
Therefore, upon inputting continuously, the input point
displays on the screen.
⑤ Click the mouse’s right button to finish inputting.
At that time, Spline displays on the screen, and the
button concaved by selection in the tool bar beco-
mes reduced at original state.
⑥ Click “Esc”in the keyboard to cancel data under inputting. This is not applied to
any data created by clicking the mouse’s right button (Applicable to all input
functions.)
■■
Creating Configuration Data
++
··
The order of ①, ②, and ③ are same. But, upon continuo-
us inputting, ④ of Spline displays just point. For point to
point input, lines are automatically connected. ⑤ and ⑥
are same to those of Spline.
··
Input Spline
··
Input Line
To Next Page
Loading...
