130
Configuration flow between PC and bartack machine
The following describes overall configuration flow for “Design direct serial
transmission”.
Design transmission flow
Start Open data
Create edit
window
Read sewing
data for edit
Create design
Set sewing size
as desired by
the user
Edit design
Store design
Direct transmission
Directly transmits the
inputted design to the
screen
Design pattern
(common file used
for SSP patterns)
OP: Serial cable connection
Important! Before transmitting design, be sure to send all the sewing data after
inserting trimming code at the last needle point. Transmission will be done even
without the trimming code, but only the main axis will move after sewing starts.
Communication set-up process is identical to zigzag design direct transmission.
However, to ensure seamless communication between SSP and the machine, be
sure to set 38400, bar tack series setting in KM-2070P 57600 for basic
communication set-up.
To Next Page
Loading...
