SunStar SSP-WE/3.5 - SSP Writer1 Program Manual

152
SSP Writer1 Program Manual
The followings summarize the functions in the program screen.
■■
Description of Program Key
For EPROM Switch
This is located to the side of SSP-Writer1. Generally place it to the left to use. If
only NS’s 27CXX series products have problems, place it to the right to use.
1. If the following message is displayed, the machine is not operated. Therefore check
the print port connection status and power supply, and execute it again.
■■
Cautions
Open Bin File
Save Buffer
Edit Buffer
DOS Shell
LPT Port
Device Type
HEX→BIN
Read ROM
Blank Check
Write ROM
Verify
Auto Write
Change Speed
Open Bin files to the program buffer.
Save the data recorded in Program Buffer to
the disk.
Display the buffer content in the screen.
Execute the DOS Shell program.
Select the print port no to be used.
Select the ROM Type device to be
programmed.
Convert HEX file into BIN file. (Not in service.)
Read ROM data to save it to the buffer.
Check if data is recorded in the ROM.
Record the program buffer content to the ROM.
Compare and verify the ROM’s content with
the program buffer’s content.
Execute Blank Check, Write ROM, and Verify in
sequence, and automatically record data to the ROM.
Change the speed to record the buffer’s
content to the ROM.
The ROM Writer program generally provides various functions and device type
ROMs. However, SSPWriter program is exclusively used for the BarTack
machine. Therefore, it is configured only with necessary functions and provides
ROM types of 27C256 and 27C512, 27C010, 27C020, 27C040 only.
“Programming Module not found
Please check connection of power Adapter”
EPROM, DEVICE
27C256, 27C512, 27C010, 27C020, 27C040
ERRER Message
The followings show device types to be provided.