79
Divide data based on the selected configuration joint.
··
Configuration Element Division
■■
Data Tool
① Click “Configuration Element Division”, then it
gets concaved.
② Click a configuration data joint to divide.
Using method is as follows:
① If you select “Grid Line”among the items of
“Sewing Command Tool Bar”on the top, the
item “Snap to Grid”shall appear. Select the
item “Snap to Grid”.
② If you don’t create grid line on editing screen, mark grid line by pressing function
key “F2”, or indicate grid line on editing screen by pressing “Grid Line Mark”on
editing tool bar in the left.
③ Now, if you input data on editing screen by pressing function key of configuration
data or user needle input button according to the shape to make a design, the
point shall be automatically moved and input to the nearest location that grid line is
crossed.
Even though you change the width of grid line, “
SSnnaapp ttoo GGrriidd
” function is
equally applied. You can change on the item “Grid Division Setting”located on
the bottommost of the item “View” of menu item of line width change. Also,
“
SSnnaapp ttoo GGrriidd
” function is applied when editing. It is equally applied
ffoorr
ccoonnffiigguurraattiioonn ddaattaa mmoovveemmeenntt,, aaddddiittiioonn ooff ccoonnffiigguurraattiioonn ddaattaa sseeggmmeenntt,,
aaddddiittiioonn ooff sseewwiinngg ddaattaa sseeggmmeenntt,, sseewwiinngg ddaattaa mmoovveemmeenntt,, eettcc..
If you want to release “
SSnnaapp ttoo GGrriidd
” function, you may set up to “Grid”
again, the original item of “
SSeewwiinngg CCoommmmaanndd TTooooll BBaarr
”.
If it is notebook user or monitor screen is less than 14 inch, all the items of
tool bar in the right may not appear due to small monitor screen. In such case,
user should directly move the tool bar to editing area in the center of screen
that the function should appear.
Reference
To Next Page
Loading...
