78
Please refer to the following for change Grid Line.
③ Select “View”in the upper menu of the program, then “Grid Division Setting”in
the lowest bottom of the Full Down menu.
④“ Grid Division Setting Dialog”is displayed. Input a setting value into horizont-
al and vertical axial input box, and click “OK”. You can find that Grid Line is
again depicted with the setting value.
Automatic point function provides very convenient function when inputting data
through grid line mark. That is, the point input to the location that grid line is
crossed is automatically moved and input to the nearest crossing point. The
following figure shows the figure being input when setting grid line to automatic
point and inputting the point at optional location.
When optional point was input, the point can be moved into 4 directions from the
location that optional point be input as shown in the left figure below. The point is
automatically moved and input on the basis of the nearest location that grid line is
crossed among them. The right figure below is that point was automatically input.
··
Automatic Point (Snap to Grid) Function
⑤ Grid line color: You can change the gray color of the line into different colors
as desired.
To Next Page
Loading...
