115
Please save it here considering the followings: The sewing machine
reads data files with the number such as 000, 001, 002. You should
save files with the same name as the above number. And if you
input various pattern designs using an actual floppy diskette, you
should make a folder of “SPC”to save them there. However, if any
floppy diskette is inputted upon clicking “Save”, “SPS”folder is
automatically created on the diskette. Therefore, upon displaying of
the Save dialog, select A:\ floppy drive, select the selected “SPS”
folder, and save files in it. If you save them in computer hard disk,
you don’t need to write the save name as the above. However, if
you input them into the sewing machine through a floppy disk, you
must do as mentioned above.
③“ Test”file in the corresponding folder is saved.
① Select File Open on the menu tool bar.
② File Open Dialog is displayed.
③ Select “Test”file and select “Open”, then the saved pattern is again displayed
on the edit range.
■■
File Open
Read the saved pattern file to display it again in the edit range.
··
Information
A saved file by SSP 3.5 is for only E-Series Machine. Only E-Series Machine can
control sewing by 0.05mm, and the other series machine can not, Therefore this file
can not apply to A/B/C/D-Series. However a file is made by SSP 3.0 or before
version of SSP can be applied for E-Series machine.
To Next Page
Loading...
