107
Embroidery Conversion Function
It provides the function to convert embroidery design file *.sst of SunStar and
*.dst of TAJIMA into pattern file. You can convert and display or save embroidery
design only up to 30,000 stitches in SSP-WE/1.0 at present. But, please
remember that you can use embroidery design only up to 20,000 stitches in
pattern machine.
Embroidery design conversion function is as follows:
① Select “Embroidery Call Function”from “Image
Punching”menu item. Upon selecting it,
“Embroidery File Call Dialogue”box appears
as shown below.
② Convert embroidery file by selecting file name and embroidery file type to create in
“Embroidery File Call Dialogue”box and pressing the opening button. Description by
each item is as follows:
③ Open Dialogue box shall appear that you can select embroidery file to call for con-
version. Select embroidery file to convert and then press “Open”button. Open
dialogue box shall disappear again and “Embroidery File Call Dialogue”shall
appear.
Embroidery File Type: It is the item to select embroidery file type to convert at
present. We selected TAJIMA file in the figure above.
OK Button: If you press “OK”button, embroidery file is converted into pattern file.
After setting up the items above, select the button “Embroidery File Open”.
Input File Name: It is the item to input the name
that embroidery file is converted and saved into
pattern file.
Embroidery File Open: It is the button to call
embroidery file to convert.
Jump Stitch Length: The default value of this
field is set to “0”. If this value is increased,
jump converts to normal stitch and is
created with default value “ 0”during
embroidery file conversion. No problems
occur for normal embroidery files, but for
those with width over 12.7mm between
stitch and stitch, increase the setup value
prior to conversion.
To Next Page
Loading...
