69
This is also similar to the above method, but this provides
““
Insert and
Move
””
functions only.
■■
Editing with the keyboard input value
① Select “Add Configuration Point Button”in the
tool bar.
② Select Keyboard Input (Add/Move) in the
Input Device as shown in the figure.
③ Upon selecting, the dialog box displays as
shown in the figure.
④ Select a configuration data joint to be inputted
(using either mouse or keyboard direction
key). The selected configuration data joint
displays in red, and the coordinate selected as
shown in the figure is displayed on the Key
Input [Add/Move] Dialog box.
⑤ Input configuration data point coordinates to
be added into the Key Input [Add/Move] box.
⑥ Click “Ok”to add the inputte coordinates.
··
Add Configuration Point
① In order to perform editing, select the “Move Configuration Data Segment”
button from the tool bar
② Perform the steps from ② through ⑥ used to “Add Configuration Data Segm-
ent.”
··
How to move configuration data segment
When applying a keyboard input(insertion/move) function and then
reapplying it, you can see that “Input(Insert/Move Keyboard)” is
checked. Therefore, in order to reapply the function, remove the check
by selecting the following item and then perform the same procedures
used at the beginning.
To Next Page
Loading...
