93
① Select configuration and sewing data to enl-
arge and reduce.
··
Enlagrement/Reduction
Enlarge and reduce the selected configuration and sewing data.
■■
Enlargement/Reduction, Rotation, Move, and Mirror
This function can be applied to both configuration data and sewing data. If confi-
guration data includes sewing data, Enlargement/Reduction, Rotation, Move, and
Mirror are applied based on configuration data, then sewing data is recreated.
Therefore all of two data can get the same effect. However, if there exists just
sewing data like Point Stitching, just sewing data is applied regardless of config-
uration data. “Whole Pattern”is not applied to the whole data with both configu-
ration data and sewing data. (Provided in the Upgrade Version.)
That is, when only sewing configuration data without sewing data exist on the
editing screen or only pure sewing data without configuration data exist, a
“Pattern All”function is applicable. (However, a reverse function is excluded.)
② Select Enlargement/Reduction to display Enlarg-
ement/Reduction Dialog. As a dialogue box
appears, the selected configuration data or
sewing data are shown in a dotted box simu-
ltaneously.
It has the following function:
Enlargement/Reduction of specified elements(range): Applied to the selected
configuration and sewing data.
X-Range: determines the enlargement/reduction range of X-axis.
Y-Range: determines the enlargement /reduction range of Y-axis.
The range is based on 100, shows 20% enlargement for 120, and 20% reduc-
tion for 80.
Increase/Decrease of number of stitches: Enlarge/reduce with the number
of enlargement/reduction stitches.
Increase/Decrease stitches length: Enlarge/reduce based on the distance
between stitches upon enlargement /reduction.
No (Origin or center): Enlarge/reduce based on the central position of the
selected configuration and sewing data.
Yes : Enlarge/reduce based on any position selected by a user.
To Next Page
Loading...
