94
③ Click “OK”to enlarge the selected configuration
and sewing data.
④ Reduce with the same method as the above.
① Select configuration and sewing data to rotate.
··
Rotation
Rotate the selected configuration and sewing data.
② Select Rotation to display Rotation Dialog.
The selected pattern is displayed to the whole
range with dotted lines as shown in the figure.
The Rotation Dialog includes the following
functions:
Rotation of whole pattern: Rotate the whole
pattern completely.
Rotation of Specified elements(range):
Rotate only the selected configuration data or
sewing data.
Angle: Input the rotation angle.
No(Origin or center): Rotate based on the
selected data.
Yes: Rotate based on any position selected by
a user.
To Next Page
Loading...
