126
② After going through 1 to 4 as explained above, you will be ready to receive
from SSP.
④ To start sewing with the inputted design, press
PARA/SET to return to sewing mode.
You will see the amplitude on the indicator.
Press PARA/SET once again.
The amplitude on the indicator will start to flash.
⑤ Press ROM pattern key.
⑥ Press +/- key to select a pattern of your choice.
⑦ Press PARA/SET again.
You can begin sewing when the amplitude is
displayed on the indicator.
③ For transmission, click “zigzag direct transmission
button”under the standard tool bar. If it goes
smoothly, you will hear a long “beep”sound instead
of repetitive beeping sounds. “ End”will be
displayed on the 2070P operation box and the
transmitting pattern number will appear on the
indicator. You will see “successfully transmitted”on
the edit screen of SSP.
If the pattern is not transmitted right even with the
“successfully transmitted”message, press the
transmission button again.
To Next Page
Loading...
