146
When the communications port window is open, select the port setup and press
the "Advanced (A)" button.
The COM advanced setup window appears.
Lastly, find "COM port number" at the bottom of the window, and select an unused
one among COM1 to COM3.
In case of SSP, only COM1, COM2, and COM3 are supported.
If COM1 remains unused, select COM1.
Before COM1 is selected, a temporary COM port is selected.
When the selection is completed, press "OK" and close all the windows related to
the setup.
Reboot the computer and ensure that COM1 remains selected. If COM1 is
selected, it means that COM port was successfully set up.
Use SSP to transfer pattern designs.
To Next Page
Loading...
