67
① Click Delete Configuration Point at Tool Bar.
(The selected button gets concaved.)
② Click a configuration data joint to be deleted.
The selected joint is in red.
③ At this time, the selected joint is deleted and a
straight line is again connected based on both
previous points.
To delete configuration data with sewing data is the
same method as foresaid. However, upon deletion
of configuration data, sewing data is created based
on the deleted configuration data. The following
shows that configuration data is deleted point to
point. Please compare it with the above figure. Add
configuration point.
··
Delete Configuration Point
For configuration data without sewing data, continue to work with the above
created data.
For configuation Point
① Click Move Configuration Point at Tool Bar.
(The selected button gets concaved.)
② Click a configuration data joint to move, the select-
ed joint displays in red.
③ Move Mouse Point, and click its left button where
to move the selected configuration data. Then you
can find that the selected configuration data has
been moved at a click place. The moved joint still
displays in a red point.
··
Move Configuration Point
For configuration data without sewing data
To Next Page
Loading...
