82
③ Click “OK”. You can find that sewing data is
created on the edit range. However you cannot
if reverse sewing data is additionally created.
Therefore you can make out whether or not the
reverse data has been created by moving
configuration data with the move function. And
the following figure shows reversely created
data between data below configuration data
upon moving and moved data.
Multi Sewing is similar to the Reverse Stitching mentioned above. This does not
create stitches reversely, but can create several same types of sewing data.
··
Multi Sewing
① Select configuration data.
② Select Multi Sewing to display Multi Sewing
Dialog. It has various input boxes: Multi-Sewing
Offset to set up the creating interval, Multi-
Sewing Offset Direction, Number of Times of
Creation, and Sewing Type divided into Regular
Stitch and Zigzag Stitch. Currently is
selected.
③ Click “OK”, then three configuration data are
created, and continuously Zigzag Dialog.
④ Set up the input value of Zigzag Dialog, click
“OK”, then you can find that zigzag type of
sewing data is created.
To Next Page
Loading...
