85
③
Press left button of mouse at the optional location of sewing data for sewing data
speed setting. Red point is made at the selected location. Then, if you press right
button of mouse, the letter “Spend”in blue is created. The first created “Spend”
includes code indicating sewing data start speed.
④ You should input the code to set up
end of sewing data setup speed again.
Click left button of mouse at the optional
location of sewing data to inform end of
setup speed. Next, a read point is made.
Then, if you press right button of mouse,
the letter “Spend”in blue is created
again, and “User Sewing Data Speed
Setting”dialogue box shall appear. The
existing “Sewing Speed Setting”button
selected dented returns to original
shape.
⑤ Input the speed to set up at “Sewing Speed Change Value”on the dialogue box
“User Sewing Data Speed Setting”. If you click arrow in the direction of
upward/downward, speed is changed. If you set up the speed, press “OK”button.
Then, dialogue box shall disappear and speed is setup. If you cancel it, all the
speed mark such as “Spend”set up to sewing data shall disappear.
We will proceed following the above process as it is.
First, we set up sewing speed and we will describe giving an example of sewing
speed setting continuously.
Such method can classify and apply into two.
1) The method to start sewing data speed setting again at the end location of already
applied sewing data speed setting.
2) The method to apply in the section other than already sewing data speed setting
was applied.
The second application process is as follows:
Spend
Spend
Spend
To Next Page
Loading...
