SunTech ST4940 - How to Set Function Parameters

Doc. Title
ST4940 User Manual
Concerning:
Rev.
Date (dd-mm-yy)
Page of Pages
Features and how to configure ST4940
1.07
0
1-7-2019
26 of 52
8-6. How to set ‘Function Parameters’
● The following table shows how to make a command to enable or disable the functions:
HDR
DEV_ID
VER
TURN_OFF
MOTION_DET_MODE
Field
Marks
Value
Meaning
HDR
“ST600FUNC”
Command type.
DEV_ID
10 char
Device ID.
VER
“02”
Protocol Version
TURN_OFF
0 / 1
0 : Lock “power key”, you can turn off the device only by
command.
1 :If you set the device to ‘1’, you can turn off the device by
using the ‘power key’ and command.
MOTION_DET_
MODE
0 / 1
Only works when Enabled. This is predefined threshold
value based on Motion. This function separated from
Regular Reporting.
As for the Emergency Alert, disabling this function does
not disable the use of the SOS button. The SOS button
will still send an EMG report, while the device works
normally. Disabling the function will only disable sending
EMG reports based on motion detection. Usually, this
function is used when you want to detect movement of
something stationary, such as a door, which is why it
keeps the device in Parked mode.
0 : Disable
1 : Enable
<Example>
[command]
ST600FUNC;0123456789;02;1;0
[response]
ST600FUNC;Res;0123456789;309;1;0