SunTech ST4940 - ACK of Emergency

Doc. Title
ST4940 User Manual
Concerning:
Rev.
Date (dd-mm-yy)
Page of Pages
Features and how to configure ST4940
1.07
0
1-7-2019
29 of 52
Field
Marks
Value
Meaning
CMD_ID
“Preset”
Report parameters setting values and current device status
Response includes network, report, function parameters
included in ‘SyncTrak’. It includes status of device as well.
<Example>
[command] ST600CMD;0123456789;02;Preset
[response]ST600CMD;Res;0123456789;309;Preset;NTW;1;mft;mft;mft;183.109.78.85;8024;;;;;1;RPT;180;180;6
0;3;0.10;FUNC;1;0
<NOTE>
** After power is on, the device sends to the server response string of the ‘Preset’ once.
Field
Marks
Value
Meaning
CMD_ID
“PresetA”
Report all the parameters including additional parameter.
<Example>
[command] ST600CMD;100850000;02;PresetA
[response]
ST600CMD;Res;0123456789;309;PresetA;NTW;1;mft;mft;mft;183.109.78.85;8024;;;;;1;RPT;180;180;60;3;0.10;
FUNC;1;0;SVC;1;5;10;70;5;10;70;0;0;500;300;200;ADP;T;T;0;;0;15;360;30;0;0
9-4. ACK of Emergency
Once this command is made by the server, the device will stop reporting about the occurrence of emergency. More
details are described in the ‘Meaning’ section of the table below.
Field
Mark
Value
Meaning
CMD_ID
“AckEmerg”
‘Acknowledge’ of emergency report
The server sends device this command as a response to inform
the device that the server has completed receiving all the
‘emergency reports’. And then, the device will stop sending
Emergency reports if it is in emergency state.