SunTech ST4940 - Command on How to Turn off the Device; Command on How to Set the Time Period that GPS Is Stabilized

Doc. Title
ST4940 User Manual
Concerning:
Rev.
Date (dd-mm-yy)
Page of Pages
Features and how to configure ST4940
1.07
0
1-7-2019
36 of 52
[response]
ST600CMD;Res;0123456789;309;ReqGpsOffMov;0
10-10. Command on how to turn off the device.
This command is made by the server to the device which needs to be turned power off.
Field
Mark
Value
Meaning
CMD_ID
“TurnOff”
How to turn off the device, which is operated under the option
that the power button should not allow the device to be turned
off. The option is described in a chapter of this document, ‘How
to set ‘Function Parameters’.
<Example>
[command] ST600CMD;0123456789;02;TurnOff
[response] ST600CMD;Res;0123456789;309;TurnOff
<Note>
In a case that you do not want the target device to be turned off with its power button,
you can turn off the power by sending this command to the target device.
10-11. Command on how to set the time period that GPS is stabilized.
This command is made if the device user does not want to utilize functions of motion sensing of
the device, which means that the case that the value of <VI_ON_THRES> is zero (0). In such a
case that the user wants to adjust the time period which is taken for the GPS module to find the
satellites.
Field
Marks
Value
Meaning
COMMAND
“SetGpsOnPercent”
‘10’ ~
‘80’
Users should set the value to a level ranged from 10% to
80%.
<Example>
[command]
ST600CMD;0123456789;02;SetGpsOnPercent=33
[response]
ST600CMD;Res;0123456789;309;SetGpsOnPercent