SunTech ST4940 - How to Set Geo-Fence Parameters

Doc. Title
ST4940 User Manual
Concerning:
Rev.
Date (dd-mm-yy)
Page of Pages
Features and how to configure ST4940
1.07
0
1-7-2019
25 of 52
Deep Sleep
PARKING_INTR
V [Hour]
VI_ON_THRES
LIFE TIME
[DAY]
ENABLE
1
0
12.4
ENABLE
3
0
37
ENABLE
6
0
73.3
ENABLE
12
0
144
ENABLE
24
0
278
8-5. How to set ‘Geo-fence Parameters’
● The following table shows how to set ID, position and enable state of the circular geo-fence.
HDR
DEV_ID
VER
GEO_ID
ACTIVE
LAT
LON
RADIUS
IN
OUT
Field
Marks
Value
Meaning
HDR
“ST600CGF”
Command type.
DEV_ID
10 char
Device ID.
VER
“02”
Protocol Version
GEO_ID
‘1’~’200’
Geo-fence ID.
ACTIVE
‘0’ or ’1’
enable (1) or disable (0)
LAT
String
Central latitude of circular area.
LON
String
Central longitude of circular area.
RADIUS
String
Radius of circular area.(Unit : m)
IN
Alert indicating that the vehicle enters the circular area
Enable (1) or disable (0)
OUT
Alert indicating that the vehicle gets out from the circular area
Enable (1) or disable (0)
<Example>
[command]
ST600CGF;0123456789;02;1;1;-23.541485;-46.656532;3550;1;1
[response]
ST600CGF;Res;0123456789;309;1;1;-23.541485;-46.656532;3550;1;1