SunTech ST4940 - Command on How to Request Data Relating to Circular Geo-Fence

Doc. Title
ST4940 User Manual
Concerning:
Rev.
Date (dd-mm-yy)
Page of Pages
Features and how to configure ST4940
1.07
0
1-7-2019
33 of 52
Field
Mark
Value
Meaning
CMD_ID
“InitCircleGeo”
Erase all circular geo-fence data.
<Example>
[command]
ST600CMD;0123456789;02;InitCircleGeo
[response]
ST600CMD;Res;0123456789;309;InitCircleGeo
10-5. Command on how to request data relating to Circular Geo-fence
This command is used if the device is required to report to the server with all of the geo-fence parameters that are pre-
set.
Field
Mark
Value
Meaning
CMD_ID
“ReqCircleGeo”
 Report the enabled circular geo-fences.
 Response consists of continuous field (0 or 1) and
information about all the geo-fences including the first
geo-fence up to the last one whose last digit is 1 (One).
<Example>
[command]
ST600CMD;0123456789;02;ReqCircleGeo
[response] Case that unit has 3 geo-fences :
ST600CMD;Res;0123456789;309;ReqCircleGeo;1;1;1;-23.549825;-46.648293;3048;1;1
ST600CMD;Res;0123456789;309;ReqCircleGeo;1;2;1;-23.539911;-46.686745;1422;1;0
ST600CMD;Res;0123456789;309;ReqCircleGeo;0;3;1;-23.531727;-46.591988;1985;0;1
Case that unit has no geo-fence.
ST600CMD;Res;0123456789;309;ReqCircleGeo;NoData
<Notes>
** Continuous field of the above response string represents bold.