SunTech ST4940 - Command on How to Reboot; Command on How to Set Google Map Address; Command on How to Get Google Map Address

Doc. Title
ST4940 User Manual
Concerning:
Rev.
Date (dd-mm-yy)
Page of Pages
Features and how to configure ST4940
1.07
0
1-7-2019
34 of 52
10-6. Command on how to Reboot
This command is made by the server to the device which needs to be rebooted.
Field
Mark
Value
Meaning
CMD_ID
“Reboot”
Reboot device.
<Example>
[Command] ST600CMD;0123456789;02;Reboot
[response] ST600CMD;Res;0123456789;309;Reboot
10-7. Command on how to set Google Map Address
In a case that you use a smart phone operating a function of “Where Are You”, you can use the server of the Google as
set below in italic bold letters, “Google map address”. The users of the Google map should check what the right map
address of the Google is and that the right address should be set. The Google map address needs to be checked. If
the Google map address is not right, this function (“Where Are You”) can’t be used.
Field
Mark
Value
Meaning
CMD_ID
“SetGoogleMap”
Set location link address format (Google map address).
This command is either followed by “=” or inserted inside the
address.
<Example>
[command] ST600CMD;0123456789;02;SetGoogleMap=http://maps.google.com/maps?q=
[response] ST600CMD;Res;0123456789;309;SetGoogleMap=http://maps.google.com/maps?q=
<Note>
The max of input string is 96 characters.
10-8. Command on how to get Google Map Address
In case this command is made, the pre-set existing Google Map address will be known.
Definition: Get Google Map Address.
Field
Mark
Value
Meaning