SunTech ST4940 - Alert Report

Doc. Title
ST4940 User Manual
Concerning:
Rev.
Date (dd-mm-yy)
Page of Pages
Features and how to configure ST4940
1.07
0
1-7-2019
45 of 52
<Note>
Emergency reports are sent EMERG_INTERVAL times until the device receives an Acknowledgement from its
server. Refer to Chapter 8-2 of this Manual.
11-3. Alert Report
Device sends ‘Alert’ to the server as defined by user in the course of setting the relevant parameters. Most of cases that
requiring an alert to be issued means that the vehicle or asset or its driver is in danger or is almost in danger that should
be notified by device to the server and/or the cellular phone (If communication via SMS has been configured) for warning.
ST4940
HDR
DEV_ID
MODEL
SW_VER
DATE
TIME
CELL_ID
MCC
MNC
LAC
RX_LVL
LAT
LON
SPD
CRS
SATT
FIX
DIST
PWR_VOLT
RESERVED
ALERT_ID
RESERVED
RESERVED