SunTech ST4940 - Re-Setting (Restoring to Factory Defaults and Rebooting); Command on How to Access to Maintenance Server to Check for Update

Doc. Title
ST4940 User Manual
Concerning:
Rev.
Date (dd-mm-yy)
Page of Pages
Features and how to configure ST4940
1.07
0
1-7-2019
38 of 52
Field
Mark
Value
Meaning
CMD_ID
“Diagnosis”
Check the device status.
<Example>
[Command]
ST600CMD;0123456789;02;Diagnosis
[response]
ST600CMD;Res;0123456789;309;Diagnosis;20160728:060720;GPS-Fixed;GPRS/HSPA-OK
<Note>:
 As the contents of the following that are included in the response statement.
20160725:105815 - Date:Time
GPS - OFF / Fixed / Not Fixed / Chipset Fail
GPRS/HSPA - OK / Server Communication Fail / Communication Fail / No Network / Pin Locked / No SIM
10-13. Re-setting (Restoring to factory defaults and Rebooting)
Once this command is made, some interactions will be made between the server and the device as described in the
‘Meaning’ section of the table below.
Field
Mark
Value
Meaning
CMD_ID
“Reset”
Re-setting the current parameters values
This command is used to initialize all the parameters with the
values set in the factory of the devices and to reboot the device.
<Example>
[command] ST600CMD;0123456789;02;Reset
[response] ST600CMD;Res;0123456789;308;Reset
10-14. Command on how to Access to maintenance server to check for update
Following table shows command to access to maintenance server directly.
Field
Mark
Valu
e
Meaning
CMD_ID
“ReqConMntSvr”
Access to maintenance server.