SunTech ST4940 - How to Set Report Parameters

Doc. Title
ST4940 User Manual
Concerning:
Rev.
Date (dd-mm-yy)
Page of Pages
Features and how to configure ST4940
1.07
0
1-7-2019
20 of 52
8-2. How to set ‘Report Parameters’
● The following table shows how to set intervals of location report, alert and how to set sensor value to sense if any
motion is made.
HDR
DEV_ID
VER
MOVING_STOP_INTRV
MOVING_INTRV
EMERGENCY_INTERVAL
EMERGENCY_ALERT_NUM
MOTION_DET_THRES
PRM_ENABLE
Field
Marks
Value
Meaning
HDR
“ST600RPT”
Command type.
DEV_ID
10 char
Device ID.
VER
“02”
Protocol Version
MOVING_STOP_IN
TRV
String
Second
Sending interval of location report while Moving stop.
Range : 0, 5 to 86400
If zero, the device doesn’t send location report periodically.
MOVING_INTRV
String
Second
Sending interval of location report while Moving.
Range : 0, 5 to 60000
If zero, the device doesn’t send location report periodically.
EMERGENCY_INT
ERVAL
String
Second
Sending interval of alert about carrying out
Range : 0, 5 to 180
If zero, checking of carrying is disabled.
EMERGENCY_ALE
RT_NUM
String
Number of attempts to send an emergency report until the
device gets acknowledgement from the server.
If 0, no Emergency Report will be sent.
If 65500, unlimited report until get ACK from Server.
MOTION_DET_TH
RES
String
Threshold value of the sensor to check if movement of the
object is made when working mode is set to Motion Detection
Mode
Range: 0.0 to 1.9
However, it is highly recommended that the value should be
0.10.
PRM_ENABLE
‘0’ / ‘1’
Device IP report is enabled on parameter report, including
device IP information assigned from PDP when connected on
UDP