[response]
ST600NTW;Res;0123456789;309;1;mft;mft;mft;183.109.78.85;8024;;;;;1
ST600NTW;Res;0123456789;309;A1;mft;mft;mft;183.109.78.85;8024;;;;;1
<Notes>
** If the Network does not require User ID and Password, these fields should be empty.
** If CMD_FROM_SERVER is enabled, the device should keep connection with the server though GPRS/HSPA
so that the device can receive a command from the server.
Sometimes, the device may send ‘Alive Report’ to keep the connection because the network provider may
disconnect the GPRS/HSPA connection if there is no communication for such a time-period. Also, the device
may send‘Alive Reports’ to re-connect with the server while the device is disconnected from the server.
Automatic Setting for GPRS/HSPA Network
If you set the device to ‘Automatic GPRS/HSPA Set’, the device will automatically set the parameters for
GPRS/HSPA with the data available on the inserted SIM card.
For instance, if Airtel SIM is inserted, the device will set ‘AUTH’ to ‘0’, ‘APN’ to ‘airtelgprs.com’, ‘USER_ID and
USER_PASS’ to empty respectively.
And then, the device reports response string after adding real GPRS/HSPA parameters, if ‘Automatic GPRS/HSPA
Set’ is selected.
DNS
SEVER_IPand B_SERVER_IP field can be filled with direct IP address (for example 111.111.111.111) or domain
name (for example, suntechint.com). If this field is written by domain, the device will find real IP address by DNS
and sends reports to IP address.
The combination of the order to use the GPRS/HSPA and SMS.
To Next Page
Loading...
