SunTech ST4940 - Page 18

Doc. Title
ST4940 User Manual
Concerning:
Rev.
Date (dd-mm-yy)
Page of Pages
Features and how to configure ST4940
1.07
0
1-7-2019
18 of 52
*PAP : Password Authentication Protocol
*CHAP : Challenge Handshake Authentication Protocol
APN
String
Access Point Name
USER_ID
String
ID for GPRS/HSPA Access
USER_PWD
String
Password for GPRS/HSPA Access
SEVER_IP
String
Server IP Address
SEVER_PORT
String
Server Port
B_SERVER_IP
String
Backup Server IP Address
B_SERVER_PORT
String
Backup Server Port
SMS_NO
String
Phone number through which device sends SMS report.
This can be used for backup in an area where GPRS/HSPA
condition is not good. Alternatively, it can be used as main
reporting method when IP and Port are empty. If you do not
use this, it should remain empty.
If some phone numbers have been registered on ‘SMS_NO’
and they are set properly, only SMS messages of which phone
numbers were registered can be accepted as command. The
SMS of which phone numbers have not been pre-set, those
SMS messages coming from those phone numbers are
disregarded.
“SMS_NO” has to be set with a number more than 7 digits
and please use the number without international code such as
“+55”.
PIN_NO
String
PIN Number to release PIN lock if it is enabled
CMD_FROM_SERV
ER
‘0’ / ‘1’
Receive command via GPRS/HSPA
‘0’ : Disable (When server doesn’t send command via
GPRS/HSPA)
‘1’ : Enable
<Example>
[command]
ST600NTW;0123456789;02;1;mft;mft;mft;183.109.78.85;8024;;;;;1
ST600NTW;0123456789;02;A;;;;183.109.78.85;8024;;;;;1